Support Home Portal Log in
Open navigation

Configuring 4-20mA sensor readings on the Hawk

The 4-20mA interface is common for industrial sensors. Such sensors output an amperage between 4mA and 20mA proportional to the signal (pressure, temperature, moisture, vibration) they are measuring. 

Wiring

When using the Ag-Tech1 plug in card, the I/Os of interest are:


Hawk IOFunction
2VBoost
53.3V output
94-20mA


4-20mA sensors typically come with 3 wires, and the below connections should be made:


4-20mA Sensor LineConnection
VCC
(Voltage Input - usually 3V3 or 5V)
  • 3V3 sensor: connect to I/O 2 - 3V3 output
  • 5V Sensor: Connect to I/O 5 - VBoost
GNDConnect to Hawk GND
4-20mA Signal LineConnect to I/O 9 - 4-20mA input


Configuration

We now need to configure the Hawk to

  1. Wake up on a schedule to take a reading - (Set up a Task)
  2. Power on the sensor at the correct voltage (via the Vboost or 3V3 rail)
  3. Sample the sensor after some time (warm up delay)
  4. Log the reading and optionally upload. 

Configure Task

Configure a task at your chosen frequency - choosing 4-20mA Action 1 as an action.

Configure Ag-Tech1 parameters

3V3 Sensor

If we have a 3V3 Sensor, we configure the 3V3 rail to be powered when the 4-20mA Action is done.

5V or 12V Sensor

If we have a 5V/12V sensor, we set the Vboost rail to be activated when doing a 4-20mA action.

We can set the Vboost Output Voltage Level to 5V or 12V

4-20mA parameters

Set the power on delay and the Analogue which the reading should be mapped to.


Reading Conversion

The reading is reported in µA - divide by 1000 to get to mA

i.e. a reading of 4250 seen in the data = 4.250mA


Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.