Dart Firmware Release Notes
Written by Matthew Clark-Massera
Updated at January 26th, 2023
Table of Contents
Subscribe To Updates
Subscribe to our technical newsletter to be notified of bug fixes and firmware updates
Dart Application Firmware - this applies to the original Dart, and not Dart2.
| v1.21 | Added an async message request for uploading accident data. |
| v1.20 | Added onboard odometer/run hours |
| v1.19 | Obtain and save cell tower information in debug logs whilst in recovery mode. |
| v1.18 |
Fixed logic error in temperature based battery charger control. Power saving pin mux fixes. Updated UART driver. |
| v1.17 |
Recovery mode timeout. Position SMS functionality. Charging disabled below -1 deg c. GPS fail notify support. |
| v1.16 | Fixed unresponsive ADC after WD Reset |
| v1.15 |
Run detect will end trips correctly after a mid-trip reset Guard against unresponsive modem AutoAPN additions |
| v1.14 |
Disable battery charging above 48 degrees. Feature can be disabled. Disable movement trips with movement threshold set to 0xFFFF. Calibrate processor temp sensor with more reliable modem temperature. Fix GSM SIM Toolkit disable loop. |
| v1.13 |
Removed 2G disable GSM restart time increased from 10 to 30s Reduced failed connection reset number to 50 Fully disable all I/O when powering down modem Reading modem fw version on first power on |
| v1.12 |
Disabling 2G on 3G devices Reduced failed connection reset number to 80 Reading network code failures from modem |
| v1.11 | Reset after 100 failed connection attempts Extra GSM debug logging after multiple failed connection attemps |
| v1.10 | Parameterised roll threshold. |
| v1.9 | Movement trip start speed threshold |
| v1.8 | RTC update |
| v1.7 | Added parameter for buzzer beeps on harsh driving event. |
| v1.6 |
Driver ID from iButton reader. Accident detection and logging levels added as: off; log reason only; log reason and reconstruction data. Idle monitoring on device. Sets a digital input on idle event if enabled. |
| v1.5 |
Driver ID from RFID TTL peripheral support added. Buzzing via RFID peripheral added. Driver lists tested Recovery mode log reasons for control from TG Immobilisation log reasons for control from TG Debugging baud rate is now 9600 bps Extended SGACT? timeout to 10 sec accDSP merged in supporting driver profiling and accident detection v1.4 RTC leap year fix |
| v1.3 |
Fixed updating of the RTC from the Hello message response. Trip trimming is disabled by default. |
| v1.2 | Initial release |
