General

Generals articles relating to the Dart

Dart Driver ID Options
The latest Darts supports two forms of Driver ID input: (Default) DM RFID Reader: the reader plugs into the Molex connector and re...
Tue, 25 Oct, 2016 at 4:28 PM
Dart - OBD Harness, Cigarette Lighter Harness and normal 12 wire harness options
Some options to make installations as easy as possible. Note that the OBD harness supplies power and ground to the Dart - the Dart does not re...
Wed, 21 Sep, 2016 at 2:01 PM
Dart Current Draw
On a 12V supply, the Dart draws the following current: State Current GSM & GPS on (in trip)...
Thu, 22 Sep, 2016 at 2:47 PM
Dart iButton Capable Serial Number Range
The original Dart hardware design was modified to support Dallas iButton Driver ID on the 4 way Molex Harness. This modification is made on serial num...
Tue, 25 Oct, 2016 at 4:27 PM
Connect an iButton Reader to the Dart
Before you start: Ensure your Dart is iButton capable. This should be on serial numbers newer than 122000 If you are using an LED, ensure there is...
Thu, 17 Nov, 2016 at 8:52 PM
Dart Immobilisation Setup Wiring Discussion
The Dart has an immobiliser function. WARNING: immobiliser functions should only be used with the vehicle starter motor for safety reasons. Please r...
Tue, 16 May, 2017 at 10:44 PM
Dart Digital Input Voltage On/Off Thresholds
Ignition: 5V on/off threshold. Input 1 & 2 with pull ups enabled: low at 0.8V, high at 1.0V. Input 1 & 2 with pull downs enabled: low at 2.0V, hig...
Mon, 11 Jun, 2018 at 4:21 PM
Dart Driver ID Diagram
Dart Driver ID Diagram
Thu, 2 Mar, 2017 at 3:54 PM
Dart Release Notes
Dart Application Firmware v1.18 - Fixed logic error in temperature based battery charger control. - Power saving pin mux fixes. - Updated UART driver...
Thu, 24 May, 2018 at 7:48 PM
Dart Default Input Mappings
The Dart has the following digital inputs mapped by default, it is important to keep these in mind when mapping inputs to avoid clashes.  Digital Inputs...
Mon, 11 Jun, 2018 at 4:32 PM