Support Home Portal Log in
Open navigation

Battery Life Estimates [Yabby Edge Cellular]

The Yabby Edge uses advanced low-power location-solving techniques to provide exceptional battery life - allowing 'deploy once' operation. The batteries will not need to be changed for an assets useful life! This cuts down on cost, effort, and potential issues. 

How does it save power?

"Traditional" devices with on-board GPS modules will wake when it is time to get a fix, and start listening for satellite signals. It continues to receive and process these signals, until either:

  1. a fix is obtained that meets the configured accuracy requirements are met.
  2. It times out (default timeout 60 sec)

The scanning and processing uses energy. There is an energy cost for every second the module spends on. So fixes that take longer burn up more battery. A typical 'cold start' fix takes around 30 seconds - so if we go undercover where there is no GPS, and the fix fails, we use twice the energy!  

In contrast, the Edge simply wakes, scans for GNSS and Wi-Fi signals for around 8-14 seconds. It then passes this raw data to the server. This uses about 1/10th of the energy of on-board GPS! If we are out of GPS coverage, the Edge doesn't waste energy constantly trying for a fix.

The caveat is that the device is not working 'as hard' to keep trying for a more accurate fix. Some fixes obtained via this method may be less accurate than on-board GPS. We are trading ultimate accuracy for battery life. However consider the battery life at 2 daily updates:

  1. Yabby GPS = 2.5 years
  2. Yabby Edge = 10 years!

The Results

# of Daily UpdatesBattery Life - Yabby GPS Battery Life - Yabby Edge
13 years10 years
21.5 years10 years
40.9 years8 years
12*0.5 years3.5 years
24*12 weeks2 years

*We would not ordinarily configure a device for 24 updates per day using periodic tracking (i.e. hourly updates). We would use 'smarter' adaptive-tracking features. See Configuring Device Heartbeat

Movement Based Tracking Battery Life Calculator

Parameters:

Trips Per Week and Average Length of Trip are required as when in movement based tracking mode - the update rate is increased (using more energy) than when stationary. 

Upload Period in Trip:
Time between uploads when moving

Log Period in Trip:
Time between location scans when moving

Network Settings for super-long battery life

In order to maximize battery life, some network settings should be applied - which will allow the device to abort an upload early (within 5 seconds) if it detects it is out of cellular coverage - instead of wasting 3 minutes trying to get on the network! See Key Parameter Optimisations - Yabby Edge Cellular

Monitoring Battery Status

Make sure to see Battery Monitoring - Yabby Edge Cellular for information on how to configure low battery alerts.

Battery Life is more Deterministic (true to calculator)

On the Yabby Edge, a scan takes a similar amount of energy every time, whether we're indoors, outdoors, in a basement etc. The actual result may change (i.e. we may get the location from Wi-Fi instead of GNSS) - but moving to an area out of GPS coverage does not result in the device using extra energy working to get a fix, reducing battery life. 

The same can be said if Early Registration Abort is configured, the energy spent on a failed upload is normally about 20x more than a succesful one! When enabled, the energy usage is about the same! Energy isn't wasted trying to find the network when out of coverage.

This means that it is easier to predict battery life accurately, as the energy usage isn't dependant on the signal conditions.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.