The SensorData has 2 analog inputs which can be used to measure voltages up to 30V. Outputs on the device can be enabled just before sampling, to power external sensors. Sampling occurs over roughly 100 ms, in which multiple readings are taking, and the average is calculated to be sent over the network. The following parameters are configurable:


Enable 3.3V: Enables the 3.3V output when taking a sample.

Enable Vout:  Enables Vout when taking a sample. This can be either 6 or 12V, depending on whether output boost is enabled on the circuit board (using the jumper).

Power On Delay: How many seconds after enabling outputs the device will wait, before taking a sample. Can be used to give external sensors enough time to power on fully. This delay is ignored if no outputs are to be enabled.