The SensorData supports I2C peripherals, such as Digital Matter Temperature Probes, and Temperature/Humidity Sensors


The SensorData and SensorNode expose 4 screw terminals for I2C,  these are marked on the board. 

  • 3.3V: provides power to the sensor at 3.3V
  • SDA: I2C data line.
  • SCL: I2C clock line.
  • GND: ground connection to the sensor.


Below are the pin outs for the wiring of Digital Matter sensors. 


DM Temperature/Humidity Sensor

  • Red = Positive - connect to 3.3V
  • Brown = Clock - connect to SCL
  • Green = Data - connect to SDA
  • Black = Ground - connect to GND
  • Purple = Not used
  • Orange = Not used


DM Temperature/Humidity Sensor wired to SensorData



DM Temperature Probe

  • Red = Positive - connect to 3.3V
  • Brown = Clock - connect to SCL
  • Orange = Data - connect to SDA
  • Black = Ground - connect to GND


New DM Temp Sensor:

In 2018 we introduced a new temperature sensor that allows you to set the address to Address 1 or Address 2:

  • Address 1 (DM Temp Sensor 1): Green - connect to 3.3V
  • Address 2 (DM Temp Sensor 2): Green - connect to ground
  • The rest of the wiring stays the same


DM Temp Probe wired to SensorData