This article describes the Remora LED behaviour.
|Off||If the LED is not on at all, it is likely that the battery is flat, or that the device is asleep. Measure the battery voltage with a multimeter. If there is charge and you wish to see some activity reset the device by removing and replacing the batteries.|
|From power-on-reset, LED flashes for duration of startup connect, fix, connect. Or until 10 min have passed.||After a reset of the device, the LED will flash. It will continue to flash until it has completed its startup sequence of: connect to server (4Hz flash); get a GPS fix (1Hz flash); and reconnect to the server (4Hz flash). If the connections are not successful, this will timeout after 10 minutes.|
|After first sleep - off||After the startup sequence has completed (connect, fix, connect) or after 10 min, the LED will be switched off. No LED flashes will occur, until a power-on-reset, or tamper.|
|On tamper - single flash||The LED will go on for 200ms when a tamper is detected.|
|In Recovery Mode - flashes in trip||The LED will flash once every 5s during trips in recovery mode.|