In order to use a Teltonika device with Telematics Guru the following settings have to be adhered to.
- Record order has to be "oldest first".
- All records need to be set to "Low" priority. High priority records are ignored to avoid sequence number corruption.
- Data protocol should be TCP/IP. Not UDP.
- See the table below for URL and port details.
Ignition and trips are triggered on Input 1.
The following optional analogue values can be mapped.
| Teltonika Description | Telematics Guru Analog # |
| Analog 1 | 1 * |
| Battery Voltage | 2 |
| External Voltage | 3 * |
| Dallas Temperature 1 | 4 |
| GSM Signal Strength | 5 * |
| LVCAN Accelerator Pedal Percentage | 6 |
| LVCAN Fuel Level | 7 |
| LVCAN Engine RPM | 8 |
| LVCAN Fuel Level Percentage | 9 |
| Dallas Temperature 2 | 10 |
(Note: * Mapped by Default)
Inputs
| Teltonika Input Name | Bit # |
| Ignition | 0 |
| Input 1 | 1 * |
| Input 2 | 2 * |
| Input 3 | 3 * |
| Immobiliser | 4 |
| Authorized Driving | 5 |
| Movement Sensor | 25 |
| GPS Power | 26 * |
| Deep Sleep | 27 * |
(Note: * Mapped by Default)
Outputs
| Teltonika Output Name | Bit # |
| Output 1 | 0 |
| Output 2 | 1 |
URL and Port details
Devices should send their data to this location:
<device-region>.telematics.guru:8982
The device region in the URL is important to target the correct regional instance of Telematics Guru. Refer to this article for an explanation of the regions and the device specific URLs. A short summary is:
| Region | Device URL |
|---|---|
| Global (old) | telematics.guru:8982 |
| APAC01 | device-apac01.telematics.guru:8982 |
| APAC02 | device-apac02.telematics.guru:8982 |
| APAC03 | device-apac03.telematics.guru:8982 |
| EMEA01 | device-emea01.telematics.guru:8982 |
| EMEA02 | device-emea02.telematics.guru:8982 |
| EMEA03 | device-emea03.telematics.guru:8982 |
| AMER01 | device-amer01.telematics.guru:8982 |
Based on which regional server your partner account is hosted you will need to use the related URL.
Avoid using the IP address if possible.